EVA1

Source

This content is based on Cyanview's official manuals. Always check the official page for the latest information and precise specifications.
https://support.cyanview.com/docs/Integrations/Panasonic/EVA1

Overview

The Panasonic AU-EVA1 provides remote control and multiple direct access functions. Attach a supported USB-to-Ethernet adapter to the camera's USB port, and the RCP controls the camera over IP (LAN).

Main Adjustments

Function	Notes
OSD menus	All functions available
Exposure	Iris *1 *2, Shutter, Gain, Auto Exposure
White balance	Auto (ATW), One Push, Manual
Primary corrections	Master Black *1, Master Gamma, Color Gains, Saturation
Lens *2	Iris, Focus, Auto focus, Zoom
Other	Detail Enhancement, Digital Zoom *1, White Clip

*1 Not supported on all models. *2 On zoom block cameras.

note

Red and blue gains are not supported by the AU-EVA1 protocol.

Setup

USB Connection

The AU-EVA1 is controlled over IP using one of the supported USB-to-Ethernet adapters listed below. Other models will not work.

• UGREEN USB 3.0 to Ethernet RJ45 Lan Gigabit Adapter for 10/100/1000 (SKU 20256; make sure to order the USB 3.0 version, not the USB 2.0 version)
• Plugable USB3.0 Gigabit Ethernet Adapter
• BUFFALO Wired LAN adapter LUA4-U3-AGT

Connecting

1. Plug the USB-Ethernet adapter into the top back of the camera

   

2. Connect both the AU-EVA1 and the Cyanview RCP to a PoE network

Camera Setup

1. Verify that the AU-EVA1 firmware is version 3.00-00-0.00 or later

2. In the camera menus, select NETWORK SETTINGS

3. Under NETWORK FUNC, either delete all accounts or add an account named guest with the password auguest (all lowercase)

4. Under NETWORK PROPERTY, set TYPE to INFRA(MANUAL)

5. Set DHCP to OFF (this example keeps the default IP address 192.168.0.1)

6. Change NETWORK SEL from OFF to WLAN

7. Power cycle the camera to apply the network changes

   

caution

When you change the network configuration or user account, you usually need to power cycle the camera to apply the changes.