Skip to main content

CI0 Power Supply

Source
This content is based on Cyanview's official manuals. Always check the official page for the latest information and precise specifications.
https://support.cyanview.com/docs/Manuals/CI0/CI0Manual

CI0 can be powered by PoE+ or by an external 12V 2A DC power supply.

  • With PoE: the output voltage on the camera port connectors is a regulated 12V DC.
  • With DC IN: the voltage is not regulated. The input voltage is present on the 2 camera ports, so make sure the connected cameras support the voltage you supply on DC IN.

CI0 power specification

DC IN​

  • Input voltage: 10V to 24V
  • The input voltage is applied directly to the camera. If you power from batteries, make sure the camera supports the higher battery voltage as well.
  • For thermal reasons, camera consumption should not exceed 12W per port

PoE+​

  • Power delivered: 12V 1A (depends on the network switch's specifications)
  • For most mini-cameras, regular PoE is enough and PoE+ isn't necessary.

Power Plug​

  • Switchcraft 762K or compatible (5.5×2.1mm, locking type)
  • A D-TAP to locking DC cable can also be used
  • To make a custom cable, cut a Digikey 10-00110 cable in half

Power connector Switchcraft 762K pinout

:::danger Be sure to check this Incorrect power voltage or polarity can damage the CI0 unit or the camera. Before installation, always check the latest specifications and pinout in the official Cyanview manual. :::