RCP Power Supply

Source

This content is based on Cyanview's official manuals. Always check the official page for the latest information and precise specifications.
https://support.cyanview.com/docs/Manuals/RCP/RCPInstallation

The RCP can be powered in either of the following two ways.

1. PoE (Power over Ethernet)

• Standard: IEEE 802.3af compliant
• A single LAN cable carries both control communication and power at the same time.

2. External Power Supply

• Input: DC +12V 200mA
• Acceptable voltage range: 9V to 24V
• Connector: Switchcraft 762K (or equivalent, 5.5 x 2.1mm)

:::danger Be sure to check before proceeding Incorrect supply voltage or connector polarity can damage the RCP unit. Before installation, always check the latest specifications and pinout diagram in the official Cyanview manual. The figures on this page are for reference only — always defer to the official documentation as the authoritative work instructions. :::